DHCP Settings for the 2Wire 2700HG-D - vQT04-6.1.5.48Router Sceenshot

Back to the 2Wire 2700HG-D - vQT04-6.1.5.48



Screenshots from PortForward.com


Advanced Setup - IP Addressing - DHCP Settings Modem Status Quick Setup Wireless Setup Utilities Advanced Setup qwest.com help Thursday, November 18, 2010 08:21:17  PM Blocking/Filtering Services Blocking Website Blocking Scheduling Access Broadband Settings IP Addressing DHCP Settings LAN IP Address WAN IP Address NAT Mapping QoS IP QoS Settings Upstream IP QoS Settings Downstream Remote Management Remote Management Routing Static Routing Security Admin Username and Password Advanced Port Forwarding Applications DMZ Hosting Firewall Settings Firewall Monitor Advanced Firewall Configuration CONNECTION STATUS: Qwest Broadband: CONNECTED 1536/512Kbps ISP Status: CONNECTED DHCP Settings Your Broadband Modem will automatically assign an IP Address to each device in your network. If you are using an additional Router to assign these IP Addresses, you will need to disable DHCP. 1. Set the DHCP server state. If "Disable" is selected proceed to step 5 below to apply the change. DHCP Server: Enable Disable   2. Set the IP addressing values. Beginning IP Address: Ending IP Address: Subnet Mask:   3. DHCP Server Lease Time:   Hours   4. Set the DNS values. DNS: Dynamic Static DNS Server 1: DNS Server 2:   5. Click "Apply" to save your changes.   Copyright 2008 Qwest Communications, Inc.