DHCP Settings for the 2Wire 2701HG-D - QwestRouter Sceenshot

Back to the 2Wire 2701HG-D - Qwest



Screenshots from PortForward.com


Advanced Setup - IP Addressing - DHCP Settings Modem Status Quick Setup Wireless Setup Utilities Advanced Setup qwest.com help Tuesday, September 22, 2009 09:08:33  AM Blocking/Filtering Services Blocking Website Blocking Scheduling Access Broadband Settings IP Addressing DHCP Settings LAN IP Address WAN IP Address NAT Mapping QoS IP QoS Settings Upstream IP QoS Settings Downstream Remote Management Remote Management Routing Static Routing Security Admin Username and Password Advanced Port Forwarding Applications DMZ Hosting Firewall Settings Firewall Monitor Advanced Firewall Configuration CONNECTION STATUS: Qwest Broadband: CONNECTED 1536/640Kbps ISP Status: CONNECTED DHCP Settings Your Broadband Modem will automatically assign an IP Address to each device in your network. If you are using an additional Router to assign these IP Addresses, you will need to disable DHCP. 1. Set the DHCP server state. If "Disable" is selected proceed to step 5 below to apply the change. DHCP Server: Enable Disable   2. Set the IP addressing values. Beginning IP Address: Ending IP Address: Subnet Mask:   3. DHCP Server Lease Time:   Hours   4. Set the DNS values. DNS: Dynamic Static DNS Server 1: DNS Server 2:   5. Click "Apply" to save your changes.   Copyright 2008 Qwest Communications, Inc.
Home > Screenshots > 2Wire > 2701HG-D - Qwest > DHCP Settings