RIP Configuration for the A-Link RR24APRouter Sceenshot

Back to the A-Link RR24AP



Screenshots from PortForward.com


RIP Configuration RIP Configuration Enable the RIP if you are using this device as a RIP-enabled router to communicate with others using the Routing Information Protocol. This page is used to select the interfaces on your deviceis that use RIP, and the version of the protocol used. RIP: Disable   Enable      Version: v1 v2 -->    --> Interface: br0 vc0 vc1 vc2 --> Receive Mode: None RIP1 RIP2 Both Send Mode: None RIP1 RIP2 RIP1COMPAT Interface: br0 vc0 vc1 vc2 RIP Interfaces: Select Interface Receive Mode Send Mode --> RIP Config Table: Select Interface Receive Mode Send Mode       
Home > Screenshots > A-Link > RR24AP > RIP Configuration