VPN Configure for the Ambit U10C022Router Sceenshot

Back to the Ambit U10C022



Screenshots from PortForward.com


Residential Gateway Configuration: VPN - Setup MODEM | GATEWAY | WIRELESS | VPN | PARENTAL CONTROL | FIREWALL | TOOLS VPN Enable Summary Configure L2TP / PPTP Event Log VPN - Configure Tunnel Tunnel list is EMPTY. Name   Disabled Enabled Local endpoint settings   Address group type IP subnet Single IP address IP address range Subnet . . . Mask . . . Identity type Automatically use WAN IP address IP address Fully qualified domain name (FQDN) Email address (USER FQDN) Identity Remote endpoint settings   Address group type IP subnet Single IP address IP address range Subnet . . . Mask . . . Identity type Automatically use remote endpoint IP address IP address Fully qualified domain name (FQDN) Email address (USER FQDN) Identity Network address type IP address Fully qualified domain name (FQDN) Remote Address IPsec settings   Pre-shared key Phase 1 DH group Group 1 (768 bits) Group 2 (1024 bits) Group 5 (1536 bits) Phase 1 encryption DES 3DES AES-128 AES-192 AES-256 Phase 1 authentication MD5 SHA-1 Phase 1 SA lifetime seconds Phase 2 encryption DES 3DES AES-128 AES-192 AES-256 Phase 2 authentication MD5 SHA-1 Phase 2 SA lifetime seconds       Key management Auto (IKE) Manual Manual Encryption Key Manual Authentication Key Inbound SPI Outbound SPI --> IKE negotiation mode Main Aggressive Perfect forward secrecy (PFS) Disabled Enabled Phase 2 DH group Group 1 (768 bits) Group 2 (1024 bits) Group 5 (1536 bits) Replay detection Disabled Enabled NetBIOS broadcast forwarding Disabled Enabled Dead peer detection Disabled Enabled NAT traversal Disabled Enabled IP payload compression Disabled Enabled -->    
Home > Screenshots > Ambit > U10C022 > VPN Configure