Advanced Settings for the Amped Wireless R10000Router Sceenshot

Back to the Amped Wireless R10000

Screenshots from

Amped Wireless High Power Wireless-N 600mW Smart Router R10000 Smart Setup Wizard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary More Settings Wireless Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Wireless Coverage Controls Access Schedule Block Websites User Access (MAC) User Access (IP) Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Advanced Settings These settings apply to the Local Network and your Internet Connection Network.  If you are not familiar with these settings, please refer to a network administrator to avoid putting your network at risk.  Enable uPNP (Universal Plug and Play)  Enable IGMP Proxy  Enable Ping Access on WAN  Enable Web Server Access on WAN (Remote Management)  Enable IPsec pass through on VPN connection  Enable PPTP pass through on VPN connection  Enable L2TP pass through on VPN connection Enable IPv6 pass through on VPN connection       Helpful Tips: By default UPnP is disabled for security reasons. With UPnP enabled, network devices may change security settings within the router's firewall to allow access over the Internet. To access the Web Menu of the router remotely, enable Web Server Access on WAN. This will allow you to control the router from a location other than the location where you router is installed.   2011 Amped Wireless /Newo Corporation. All rights reserved.
Home > Screenshots > Amped Wireless > R10000 > Advanced Settings