Advanced Wireless Settings for the Amped Wireless R10000Router Sceenshot

Back to the Amped Wireless R10000



Screenshots from PortForward.com


Amped Wireless High Power Wireless-N 600mW Smart Router R10000 Smart Setup Wizard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary More Settings Wireless Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Wireless Coverage Controls Access Schedule Block Websites User Access (MAC) User Access (IP) Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Advanced Settings Advanced wireless settings are for technically advanced users. It is recommended that these settings not be changed unless it is understood what the effects will be on your local wireless network. Fragment Threshold: (256-2346) RTS Threshold: (0-2347) Beacon Interval: (20-1024 ms) Preamble Type: Long Preamble  Short Preamble IAPP: Enabled   Disabled Protection: Enabled   Disabled Aggregation: Enabled   Disabled Short GI: Enabled   Disabled WLAN Partition: Enabled   Disabled STBC: Enabled   Disabled 20/40MHz Coexist: Enabled   Disabled       Helpful Tips: Advanced Wireless Settings should only be adjusted by technically advanced users. It is not recommended that novice users adjust these settings to aovid degrading wireless performance. View the Users Manual for more information on these settings. Quick Definitions: Fragment Threshold: The higher the value the less wireless fragmenting any frames that it sends to wireless users. This is recommended RTS Threshold: Adjusts the size of RTS data packets. Lower values reduce throughput but allow the system to recover quicker from interference/collisions. Higher values provide the fastest throughput. Beacon Interval: Indicates the frequency interval of the beacon. A beacon is a packet broadcast by the router to synch the wireless network. Preamble Type: Defines the length of the Cyclic Redundancy Check for communication between the router and roaming wireless users. IAPP: Inter-Access Point Protocol STBC: Space Time Block Coding improves reception by coding the data stream in blocks. 2011 Amped Wireless /Newo Corporation. All rights reserved.
Home > Screenshots > Amped Wireless > R10000 > Advanced Wireless Settings