MAC Address Filtering for the Amped Wireless R10000Router Sceenshot
Amped Wireless High Power Wireless-N 600mW Smart Router R10000 Smart Setup Wizard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary More Settings Wireless Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Wireless Coverage Controls Access Schedule Block Websites User Access (MAC) User Access (IP) Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password User Access Control (MAC Address Filtering) Each networking device has a physical address known as a MAC address. MAC Address Filtering blocks access to your network from computers or network devices based on their unique MAC address (physical address). To begin blocking access, enable MAC Filtering and enter the MAC address below without spaces or symbols (i.e. A1B2C3D4E5F6). Enable MAC Filtering MAC Address: Comment: Current Filter Table MAC Address Comment Select Helpful Tips: A MAC Address may sometimes be referred to as a Physical Address. Most networking devices have their MAC Address located on a label on the actual device. Be sure to enter the MAC Address without any symbols. For example, a MAC Address of 78-DD-78-AA-78-BB would be entered as 78DD78AA78BB. © 2011 Amped Wireless /Newo Corporation. All rights reserved.