Denial of Service for the Amped Wireless TAP-R2Router Sceenshot
Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: A Denial of Service attack is an attempt by a user (or users) to make a server’s or network’s services unavailable. The router can assist in preventing these attacks by scanning the network for patterns of activity that represent DoS attacks. If a pattern comes in frequently, the router can attempt to block messages containing that pattern and thus protect the server from becoming overloaded and unresponsive. Denial of Service The Router can prevent specific DoS attacks from entering your network. A Denial of Service (DoS) attack is characterized by an explicit attempt by malicious users to prevent legitimate users from use of a specific internet service. To activate your protection, enable the DoS Prevention below and configure the specific settings: Enable Denial of Service (DoS) Prevention Whole System Flood: SYN Packet/Second Whole System Flood: FIN Packet/Second Whole System Flood: UDP Packet/Second Whole System Flood: ICMP Packet/Second Per-Source IP Flood: SYN Packet/Second Per-Source IP Flood: FIN Packet/Second Per-Source IP Flood: UDP Packet/Second Per-Source IP Flood: ICMP Packet/Second TCP/UDP PortScan
Sensitivity ICMP Smurf IP Land IP Spoof IP TearDrop PingofDeath TCP Scan TCP SynWithData UDP Bomb UDP EchoChargen
Enable Source IP Blocking Block Time (sec) © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time. Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi: -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection. When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.