Port Filtering for the Amped Wireless TAP-R2Router Sceenshot
Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: Port Filtering is a security measure that prevents users from using specific ports for reasons other than what those ports were originally intended for. For example, TCP port 21 is traditionally used for FTP. However, there is nothing stopping a user from using port 21 for purposes other than FTP access. By enabling Port Filtering on TCP port 21, only FTP communications would be allowed. No other types of communication would be allowed on this port. Hackers may sometimes scan for all open ports on your network as a method of hacking into your network. Port Filtering and other firewall features help to prevent this from happening. To set up Port Filtering, select a range of ports you wish to filter. If you are trying to filter a single port, enter the port number twice. Port Filtering Port Filtering allows you to enable or disable TCP ports and UDP ports on computers or network devices. Port Filtering insulates your local computers from many TCP/IP security attacks, including internal attacks by malicious users. Enable Port Filtering Select IP Type: IPv4 (Standard) IPv6 Port Range: - Protocol: Both TCP UDP Comment: Current Filter Table Port Range Protocol IP Version Comment Select © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time. Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi: -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection. When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.