Routing Setup for the Amped Wireless TAP-R2Router Sceenshot
Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: Dynamic Routing allows the High Power router to automtically learn network destinations for devices/networks that are directly connected to the router. RIP and RIP2 are routing protocols that may be used for the router to learn routes from other routers running those same protocols. This allows the Router to adapt to changes and failures within the network topology and find the best route. Static Routing allows the administrator to manually enter into the Router’s routing table. These routes do not change and must be manually reconfigured if the route fails. Routing Setup Setup Dynamic or Static Routing protocols (for advanced users only). Enable Dynamic Route NAT: Enable Disable Transmit: Disabled RIP 1 RIP 2 Receive: Disabled RIP 1 RIP 2 Enable Static Route IP Address: Subnet Mask: Gateway: Metric: Interface: LAN WAN Static Route Table: Destination IP Address Netmask Gateway Metric Interface Select © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time. Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi: -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection. When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.