Save and Reload Settings for the Amped Wireless TAP-R2Router Sceenshot

Back to the Amped Wireless TAP-R2



Screenshots from PortForward.com


Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: The Save and Reload feature is often used for backing up current settings as a precaution. However, the feature may also be used for saving the router configurations for installation in multiple locations. If you plan on adjusting the settings on the router, the Save and Reload feature may be used to set a restore point in case there is a problem with your new settings. The router has two methods to reset the device back to factory default settings. The first is by using the soft button on this page. The other option is to use the physical reset button located on the back of the router. Pressing the reset button will reboot the router. Holding down the reset button for 5 to 10 seconds will reset it to default settings. Save/Reload Settings Save your current Router configurations to a file or reload previously saved configurations. If needed, you may also reset your Router to factory default settings. Save Settings to File: Load Settings from File: Reset Settings to Default:             © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time.  Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi:     -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection.     When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.
Home > Screenshots > Amped Wireless > TAP-R2 > Save and Reload Settings