Wi Fi 5GHz Advanced for the Amped Wireless TAP-R2Router Sceenshot

Back to the Amped Wireless TAP-R2



Screenshots from PortForward.com


Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: Advanced Wi-Fi Settings should only be adjusted by technically advanced users. It is not recommended that novice users adjust these settings to avoid degrading wireless performance. View the User's Guide for more information on these settings. Quick Definitions: Fragment Threshold: The higher the value the less wireless fragmenting any frames that it sends to wireless users. This is recommended RTS Threshold: Adjusts the size of RTS data packets. Lower values reduce throughput but allow the system to recover quicker from interference/collisions. Higher values provide the fastest throughput. Beacon Interval: Indicates the frequency interval of the beacon. A beacon is a packet broadcast by the router to synch the wireless network. Preamble Type: Defines the length of the Cyclic Redundancy Check for communication between the router and roaming wireless users. IAPP: Inter-Access Point Protocol STBC: Space Time Block Coding improves reception by coding the data stream in blocks. Advanced Settings (5GHz) These settings apply to your 5GHz Wi-Fi network. Advanced Wi-Fi settings are for technically advanced users. It is recommended that these settings not be changed unless it is understood what the effects will be on your local Wi-Fi network. Fragment Threshold: (256-2346) RTS Threshold: (0-2347) Beacon Interval: (20-1024 ms) Preamble Type: Long Preamble   Short Preamble IAPP: Enabled   Disabled Protection: Enabled   Disabled Aggregation: Enabled   Disabled Short GI: Enabled   Disabled WLAN Partition: Enabled   Disabled STBC: Enabled   Disabled LDPC: Enabled   Disabled 20/40MHz Coexist: Enabled   Disabled Tx Beamforming: Enabled   Disabled       © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time.  Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi:     -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection.     When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.
Home > Screenshots > Amped Wireless > TAP-R2 > Wi Fi 5GHz Advanced