Wi Fi 5GHz Basic for the Amped Wireless TAP-R2Router Sceenshot

Back to the Amped Wireless TAP-R2



Screenshots from PortForward.com


Amped Wireless Dashboard 1) Internet Connection 2) System Clock 3) Wireless Settings 4) Setup Summary --> More Settings 5GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule 2.4GHz Wi-Fi Settings Basic Settings Security Settings Advanced Settings Wi-Fi Protected Setup Wireless Coverage Access Schedule Network Settings Local Network (LAN) Internet Network (WAN) Advanced Settings Smart Features Block Websites User Access (MAC) User Access (IP) USB Storage Local Sharing FTP Server Firewall Settings Port Filtering Port Forwarding DMZ Virtual LAN Denial of Service Quality of Service Routing Setup Management System Status Network Statistics Dynamic DNS System Clock System Logs Upgrade Firmware Save/Reload Settings Password Helpful Tips: These settings apply to your local 5GHz Wi-Fi network. Disabling 5GHz Wireless: Turn off all 5GHz Wi-Fi activity. Broadcast SSID: Disabling SSID broadcasting of your SSID will make it so outside users cannot see your 5GHz network when they scan for wireless networks. Users must manually enter the SSID to connect. Wireless Network ID (SSID): The name of your 5GHz Wi-Fi network. Guest Networks: Add additional 5GHz Wi-Fi network names with different Wi-Fi settings. Each new SSID can have its own security setting and speed settings. Channel Number: WiFi networks operate on specific Wi-Fi channels. Some network channels may have more interference than others. If your performance is unstable, try a different channel number. If you are using a repeater with this network, it is recommended you set a static channel, instead of using "Auto." WMM: Prioritizes multimedia data over the Wi-Fi network. Associated Clients: Shows active users connected wirelessly to your 5GHz network. For more detailed information, please view the User's Guide on the included CD. Basic Wi-Fi Settings (5GHz)  Manually configure the settings for your Wi-Fi network. Basic Settings (5GHz) Disable 5GHz Wi-Fi Connections: Country: Band: Mode: AP Client WDS AP+WDS Network Type: Broadcast SSID: Enable   Disable Disabled Enabled --> Data Rate: Wi-Fi Network ID (SSID): Channel Width: 20MHz 40MHz Control Sideband: Upper Lower --> Channel Number: WMM: Disabled Enabled Associated Clients:    Enable Mac Clone (Single Ethernet Client)    Enable Universal Repeater Mode (Acting as AP and client simultaneouly) SSID of Extended Interface:         © 2014 Amped Wireless /Newo Corporation. All rights reserved. Applying Changes The router is applying your settings and may reboot during this process. This may take a few minutes, please do not make changes at this time.  Could not re-establish a connection to your Router. If you were connected wirelessly to the router please reconnect your computer/tablet to the following network: 2.4GHz WiFi:     -or- --> 5GHz WiFi: 2.4G Security: 5G Security: If you were connected using a cable, please check the cable connection.     When reconnected, press OK: If clicking OK does not work after you have reconnected to the router, try refreshing the web browser. If you still do not have access, turn the router off and back on, then try again.
Home > Screenshots > Amped Wireless > TAP-R2 > Wi Fi 5GHz Basic