Configuration for the Arris NVG468MQ - FrontierRouter Sceenshot
Advanced - Configuration NVG468MQ Version: 9.2.0h3d78 Logout WAN Link: Up Link Type: ONT WAN Link Speed: 1000 Mbps WAN Conn: Connected Conn Type: DHCP Client WAN IP: Wireless2G: Enabled SSID: Encryption: WPA2 Wireless5G: Enabled SSID: Encryption: WPA2 Skip to Main Content Main Wireless Network Firewall Advanced Status Advanced Broadband Settings Connection Settings Coax (MoCA) LAN & DHCP DHCP Reservation Ethernet Ports IPv6 DNS Routing Voice Lines QoS Utilities Administration Remote GUI Configuration Firmware Logging Reboot Advanced - Configuration Save Configuration File: WARNING: Loading a configuration file will restore your gateway to the previously saved configuration and automatically restart the gateway. Load Configuration File: Restore Default Wireless Settings: Restore Default Firewall Settings: WARNING: Restoring your gateway to factory default settings will permanently delete all configuration changes since the system was installed and automatically restart the gateway. Restore Factory Defaults: Hide Help Save Configuration File: You can save the current configuration and use it to restore your settings at a later time. Load Configuration File: Loading a configuration file saved from a previous software version may or may not restore properly. On loading a configuration file the gateway will always be restarted; it cannot be cancelled. Restore Default Wireless Settings: Restores only the wireless settings of the gateway. All other user-defined settings remain. Restore Default Firewall Settings: Restores only the firewall settings of the gateway. All other user-defined settings remain. Reset Gateway: When the gateway is reset, all configuration changes you have made will be deleted and settings will be returned to factory defaults. In addition, a restart will occur, so all users connected to the gateway or to the Internet will be disconnected. © 2017 ARRIS Enterprises, LLC. All rights reserved.