Routing for the Arris NVG468MQ - FrontierRouter Sceenshot

Back to the Arris NVG468MQ - Frontier



Screenshots from PortForward.com


Advanced - Routing NVG468MQ Version: 9.2.0h3d78 Logout WAN Link:   Up Link Type:   ONT WAN Link Speed:   1000 Mbps WAN Conn:   Connected Conn Type:   DHCP Client WAN IP:   Wireless2G:   Enabled SSID:   Encryption:   WPA2 Wireless5G:   Enabled SSID:   Encryption:   WPA2 Skip to Main Content Main Wireless Network Firewall Advanced Status Advanced Broadband Settings Connection Settings Coax (MoCA) LAN & DHCP DHCP Reservation Ethernet Ports IPv6 DNS Routing Voice Lines QoS Utilities Administration Remote GUI Configuration Firmware Logging Reboot Advanced - Routing LAN RIP Send: OFF V1 V1-COMPAT V2 V2-MD5 RIP Receive: OFF V1 V1-COMPAT V2 V2-MD5 MD5 Key: WAN WAN RIP Receive: OFF V1 V1-COMPAT V2 V2-MD5 MD5 Key: Route Name: Destination: Netmask: Gateway: Interface: Auto LAN WAN Metric: No custom route entries have been defined Hide Help RIP Send: Specify a version to enable Routing Information Protocol Transmit. RIP Receive: Specify a version to enable Routing Information Protocol Receive. MD5 Key: Key used for V2-MD5. Route Name: Custom route name. Destination: IP Address of Destination. Netmask: Netmask for the Destination. Gateway: Gateway for the custom route. Interface needs to be selected if Gateway is set to 0.0.0.0. Interface: LAN or WAN selection for the custom route. Default is Auto. Metric: Value from 0-255. © 2017 ARRIS Enterprises, LLC. All rights reserved.