Tunneling for the Cisco RV180Router Sceenshot

Back to the Cisco RV180



Screenshots from PortForward.com


RV180 Multifunction VPN Firewall Tunneling You must set the IP mode to IPv4/IPv6 mode in the Networking > IPv6 > IP Mode Page before configuring 6 to 4 tunneling. Automatic Tunneling: Enable   Remote End Point: Enable   Remote End Point IPv4 Address:   IPv6 Tunnel Status Table Tunnel Name IPv6 Addresses ISATAP Subnet Prefix   6 to 4 Tunnel   ISATAP Tunnel Table Local End Point Address ISATAP Subnet Prefix   0 results found
Home > Screenshots > Cisco > RV180 > Tunneling