Network Settings for the Dlink DAP-1522 Bridge ModeRouter Sceenshot

Back to the Dlink DAP-1522 Bridge Mode



Screenshots from PortForward.com


D-Link Corporation | WIRELESS ACCESS POINT | HOME Product Page :  DAP-1522 Hardware Version : rev 1A1  Firmware Version : 1.00  --> Setup Advanced MAINTENANCE Status Help --> Setup Advanced MAINTENANCE Status Help WIZARD WIRELESS Network Settings Logout Network Settings Use this section to configure the internal network settings of your access point and also to configure the built-in DHCP Server to assign IP addresses to the computers on your network. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again.   LAN Settings Use this section to configure the internal network settings of your access point. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC´s network settings to access the network again. LAN Connection Type :   Static IP Dynamic IP (DHCP) Access Point IP Address :   Subnet Mask :   Default Gateway :   Static IP Address LAN Connection Type Enter the static address information. Access Point IP Address :   Subnet Mask :   Default Gateway :   Dynamic IP (DHCP) LAN Connection Type IP Address information. Access Point IP Address :   Subnet Mask :   Default Gateway :   DEVICE NAME (NETBIOS NAME) Device Name :   Helpful Hints... Also referred to as private settings. LAN settings allow you to configure the LAN interface of the access point. The LAN IP address is private to your internal network and is not visible to the Internet. The default IP address is 192.168.0.50, with a subnet mask of 255.255.255.0. LAN Connection - The factory default setting is "Static IP" to allow the IP address of the access point to be manually configured in accordance with the local area network requirements. Enable "Dynamic IP (DHCP)" to allow the DHCP host to automatically assign the access point an IP address that conforms to the applied local area network requirements. 3 --> If you have a DHCP server on your network, you can select DHCP to get the IP address from a DHCP server. More...       -->     Copyright © 2008 D-Link Corporation, Inc.
Home > Screenshots > Dlink > DAP-1522 Bridge Mode > Network Settings