Network Settings for the Dlink DAP-1555 Bridge ModeRouter Sceenshot
Back to the Dlink DAP-1555 Bridge Mode
D-LINK SYSTEMS, INC. | AP/BRIDGE : Setup / Network Settings Firmware Version: 1. 00 Product Page: DAP-1555 Setup Advanced Maintenance Status Help Wizard Wireless Network Settings Reboot needed Your changes have been saved. The bridge must be rebooted for the changes to take effect. You can reboot now, or you can continue to make other changes and reboot later. Configuration Warnings Network Settings Use this section to configure the internal network settings of your bridge and also to configure the built-in DHCP Server to assign IP addresses to the computers on your network. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again. LAN Settings Use this section to configure the internal network settings of your bridge. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again. LAN Connection Type : Static IP Dynamic IP (DHCP) IP Address: Subnet Mask: Default Gateway: DEVICE NAME (NETBIOS NAME) Device Name: Helpful Hints... If you have a DHCP server on your network, you can select DHCP to get the IP address from a DHCP server. More... Copyright © 2004-2007 D-Link Systems, Inc.
