DI and DO for the Dlink DCS-3110Router Sceenshot
Back to the Dlink DCS-3110
DCS-3110 IP camera Product Page: DCS-3110 Firmware Version: 1.00 Live Video Setup Advanced Maintenance Status Help DI and DO RS485 ICR Access List Logout DI and DO The I/O connector provides the physical interface for digital output (DO) and digital input (DI) that is used for connecting a diversity of external alarm devices to the PTZ IP camera such as IR-Sensors and alarm relays. The digital input is used for connecting external alarm devices and once triggered images will be taken and e-mailed. DI and DO Digital input: The active state is High Low ; the current state detected is High Digital output: The active state is Open Grounded ; the current state detected is Open Helpful Hints.. The network camera provides a general I/O terminal block with one digital input and one relay switch for device control. Pin DI+ and pin DI- can be connected to an external sensor and the state of voltage will be monitored from the initial state 'LOW'. The relay switch of pin DO+ and pin DO- can be used to turn on or off the external device. Please refer to manual for detail connection diagram. Copyright © 2008 D-Link Corporation/D-Link Systems, Inc. All rights reserved. Untitled Document
