Network Settings for the Dlink DIR-655Router Sceenshot

Back to the Dlink DIR-655



Screenshots from PortForward.com


D-LINK SYSTEMS, INC. | WIRELESS ROUTER : Setup / Network Settings   Firmware Version: 1.32NA Hardware Version: A4 Product Page: DIR-655 Setup Advanced Tools Status Support Internet Wireless Settings Network Settings USB Settings Virtual Server Port Forwarding Application Rules QOS Engine Network Filter Access Control Website Filter Inbound Filter Firewall Settings Routing Advanced Wireless WISH Wi-Fi Protected Setup Advanced Network Admin Time SysLog EMail Settings System Firmware Dynamic DNS System Check Schedules Device Info Logs Statistics Internet Sessions Wireless WISH Sessions Menu Setup Advanced Tools Status Glossary Reboot needed Your changes have been saved. The router must be rebooted for the changes to take effect. You can reboot now, or you can continue to make other changes and reboot later. Configuration Warnings Network Settings Use this section to configure the internal network settings of your router and also to configure the built-in DHCP Server to assign IP addresses to the computers on your network. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again. Note: Only Administrator has access to these functionalities. WAN Port Mode WAN Port Mode : Router Mode Bridge Mode Router Settings Use this section to configure the internal network settings of your router. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again. Router IP Address: Subnet Mask: Device Name: Default Gateway: Primary DNS Server : Secondary DNS Server : Local Domain Name: (optional) Enable DNS Relay: DHCP Server Settings Use this section to configure the built-in DHCP Server to assign IP addresses to the computers on your network. Enable DHCP Server: DHCP IP Address Range: to DHCP Lease Time: (minutes) Always broadcast: (compatibility for some DHCP Clients) NetBIOS announcement: Learn NetBIOS from WAN: NetBIOS Scope: (optional) NetBIOS node type : Broadcast only (use when no WINS servers configured)   Point-to-Point (no broadcast)   Mixed-mode (Broadcast then Point-to-Point)   Hybrid (Point-to-Point then Broadcast) Primary WINS IP Address: Secondary WINS IP Address: Add DHCP Reservation Enable: Computer Name: << Computer Name IP Address: MAC Address:     DHCP Reservations List Enable Computer Name MAC Address IP Address Number of Dynamic DHCP Clients:0 Hardware Address Assigned IP Hostname Expires Helpful Hints... If you already have a DHCP server on your network or are using static IP addresses on all the devices on your network, uncheck Enable DHCP Server to disable this feature. If you have devices on your network that should always have fixed IP addresses, add a DHCP Reservation for each such device. More...   Copyright © 2004-2008 D-Link Systems, Inc.
Home > Screenshots > Dlink > DIR-655 > Network Settings