Wireless - Advanced Setting for the Dlink DSL-2640BRouter Sceenshot

Back to the Dlink DSL-2640B



Screenshots from PortForward.com


  ADSL Virtual Server DMZ SNMP IP Filter Bridge Filters Parental Control Routing QoS Port Mapping Certificate Wireless Logout       Wireless -- Advanced This page allows you to configure advanced features of the wireless LAN interface. You can select a particular channel on which to operate, force the transmission rate to a particular speed, set the fragmentation threshold, set the RTS threshold, set the wakeup interval for clients in power-save mode, set the beacon interval for the access point, set XPress mode and set whether short or long preambles are used. Click "Apply" to configure the advanced wireless options. AP Isolation: Off On Band: 2.4GHz Channel: Auto 1 2 3 4 5 6 7 8 9 10 11 Current: 11 Auto Channel Timer(min) 802.11n/EWC: Auto Disabled Bandwidth: 20MHz 40MHz Current: MHz Control Sideband: Lower Upper Current: N/A 802.11n Rate: 802.11n Protection: Off Auto 54g™ Rate: Auto 1 Mbps 2 Mbps 5.5 Mbps 6 Mbps 9 Mbps 11 Mbps 12 Mbps 18 Mbps 24 Mbps 36 Mbps 48 Mbps 54 Mbps Multicast Rate: Auto 1 Mbps 2 Mbps 5.5 Mbps 6 Mbps 9 Mbps 11 Mbps 12 Mbps 18 Mbps 24 Mbps 36 Mbps 48 Mbps 54 Mbps Basic Rate: Default All 1 & 2 Mbps 1 & 2 & 5.5 & 6 & 11 & 12 & 24 Mbps Fragmentation Threshold: RTS Threshold: DTIM Interval: Beacon Interval: XPress™ Technology: Disabled Enabled 54g™ Mode: 54g Auto 54g Performance 54g LRS 802.11b Only 54g™ Protection: Off Auto Regulatory Mode: Disabled 802.11h 802.11d Pre-Network Radar Check: In-Network Radar Check: TPC Mitigation(db): 0(off) 2 3 4 Afterburner Technology: Disabled Enabled Disable WMM(Quality of Service) and set Fragmentation to 2346 for selection Preamble Type: long short Transmit Power: 20% 40% 60% 80% 100%                  
Home > Screenshots > Dlink > DSL-2640B > Wireless - Advanced Setting