Bridge Filtering for the Dlink DSL-2640B SEA 1.00Router Sceenshot

Back to the Dlink DSL-2640B SEA 1.00



Screenshots from PortForward.com


Inbound IP Filtering Outbound IP Filtering Bridge Filtering Product Page: DSL-2640B Site Map       Firmware Version: SEA_1.00 Setup Advanced Maintenance Status Help Advanced Wireless Port Forwarding Port Triggering DMZ Parental Control Filtering Options Firewall Settings DNS Dynamic DNS Network Tools Routing Schedules Logout Bridge Filtering Bridge Filtering is only effective on ATM PVCs configured in Bridge mode. ALLOW means that all MAC layer frames will be ALLOWED except those matching with any of the specified rules in the following table. DENY means that all MAC layer frames will be DENIED except those matching with any of the specified rules in the following table. Create a filter to identify the MAC layer frames by specifying at least one condition below. If multiple conditions are specified, all of them take effect. Click "Apply" to save and activate the filter. WARNING : Changing from one global policy to another will cause all defined rules to be REMOVED AUTOMATICALLY! You will need to create new rules for the new policy. Bridge Filtering Global Policy: ALLOW all packets but DENY those matching any of specific rules listed DENY all packets but ALLOW those matching any of specific rules listed Bridge Filter Setup   VPI/VCI Protocol Destination MAC Source MAC Frame Direction Schedule Rule Add Bridge Filter Protocol Type : (Click to Select) PPPoE IPv4 IPv6 AppleTalk IPX NetBEUI IGMP Destination MAC Address : Source MAC Address : Frame Direction : LAN<=>WAN WAN=>LAN LAN=>WAN Schedule : Always Never    View Available Schedules WAN Interfaces (Configured in Bridge mode only)   Select All   br_0_0_35/nas_0_0_35 ALL br_0_0_35/nas_0_0_35 Helpful Hints... Create a list of MAC addresses that you would either like to allow or deny access to your network depending on the current Global Policy . Note : You must first create a Bridged connection to use Bridge Filter . You can create a Bridged connection by going to Setup -> Internet Setup . Select a schedule for when the rule will be enabled. If you do not see the schedule you need in the list of schedules, go to the Advanced -> Schedules screen and create a new schedule. More...   Copyright 2008-2010 D-Link Systems, Inc.
Home > Screenshots > Dlink > DSL-2640B SEA 1.00 > Bridge Filtering