Basic Setup for the Linksys BEFW11S4v4-1.52Router Sceenshot

Back to the Linksys BEFW11S4v4-1.52

Screenshots from

Setup Firmware Version: 1.52.02   Setup Wireless-B Broadband Router  BEFW11S4   Setup Wireless Security Applications & Gaming Administration Status Basic Setup   DDNS   MAC Address Clone   Advanced Routing   Internet Setup                 Internet Connection Type     Obtain an IP automatically Static IP PPPoE RAS(for SingTel) PPTP Heart Beat Signal L2TP                 Optional Settings (required by some ISPs)      Host Name:              Domain Name:              MTU:   Enable Disable   Size:            Speed & Duplex:   10 Mb Full 10 Mb Half 100 Mb Full 100 Mb Half Auto               Network Setup             Router IP      Local IP Address:   . . .            Subnet Mask:               Network Address Server Settings (DHCP)      Local DHCP Server:   Enable Disable            Start IP Address:       192.168.1.            Number  of  Address:              DHCP  Address  Range: ~ 149            Client Lease Time:    minutes (0 means two day)          Static DNS 1:    . . .          Static DNS 2:    . . .          Static DNS 3:    . . .          WINS:    . . .                 Basic Setup The Basic Setup screen is where basic configuration is performed. Some ISPs (Internet Service Providers) will require that you enter the DNS information. These settings can be obtained from your ISP. After you have configured these settings, you should set a router password from the Administration->Management screen. Completing the Internet Setup section is all that is required to set up for your specific ISP. Please look at the table below to configure the Router for your Internet connection. More...                       Save Settings   Cancel Changes    
Home > Screenshots > Linksys > BEFW11S4v4-1.52 > Basic Setup