Advanced Routing for the Linksys RVS4000Router Sceenshot

Back to the Linksys RVS4000



Screenshots from PortForward.com


Advanced Routing Firmware Version: V1.1.14 Setup 4-Port Gigabit Security Router with VPN RVS4000 Setup Firewall VPN QoS Administration IPS L2 Switch Status     Summary    | WAN    | LAN    | DMZ    | MAC Address Clone    | Advanced Routing    | Time    | IP Mode Advanced Routing      Operating Mode Operation Mode:   Gateway           Router This tab is for setting the Router advanced functions. Operating Mode allows you to select the type(s) of advanced functions you use. Using Routing Information Protocol (RIP), dynamic routing can automatically adjust how packets travel on your network. Static Routing sets up a fixed route to another network destination. More...   Dynamic Routing RIP: RIP Send Packet Version: RIP Recv Packet Version: Enabled          Disabled   RIPv1 RIPv2   RIPv1 RIPv2   Static Routing Select Set Number: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Destination IP Address: . . . Subnet Mask: . . . Gateway: . . . Hop Count:   Inter-VLAN Routing Inter-VLAN Routing:   Enable           Disable            
Home > Screenshots > Linksys > RVS4000 > Advanced Routing