IPSec VPN for the Linksys RVS4000Router Sceenshot

Back to the Linksys RVS4000



Screenshots from PortForward.com


VPN Firmware Version: V1.1.14 VPN 4-Port Gigabit Security Router with VPN RVS4000 Setup Firewall VPN QoS Administration IPS L2 Switch Status     Summary    | IPSec VPN    | VPN Client Accounts    | VPN Passthrough IPSec VPN   Select Tunnel Entry: --new--     IPSec VPN Tunnel: Enable   Disable Tunnel Name: Virtual Private Network (VPN) is a security measure that basically create a Security connection between two remote locations. Configure these settings so the Gateway will create VPN tunnels. More...   Local Group Setup Local Security Gateway Type: IP Only IP + Domain Name(FQDN) Authentication Domain Name: IP address: . . . Local Security Group Type: IP Addr. Subnet IP Address:  . . . Subnet Mask:  255.255. .     Remote Group Setup Remote Security Gateway Type: IP Only IP + Domain Name(FQDN) Authentication Domain Name: IP address IP by DNS Resolved . . . IP Address:  . . . This Gateway accepts requests from any IP address. --> Remote Security Group Type: IP Addr. Subnet Any IP Address:  . . . This Gateway accepts requests from any IP address. Subnet Mask:  . . .   IPSec Setup Keying Mode: IKE with Preshared key Manual Phase 1: Local Identity: Local IP address FQDN: Remote Identity: Remote IP address FQDN: --> Encryption: 3DES   Authentication: MD5   SHA1   Group: 768-bit 1024-bit 1536-bit Key Life Time:   Sec. Phase 2: Encryption: 3DES   Authentication: MD5   SHA1   Perfect Forward Secrecy: Disable Enable Preshared Key:   Group: 768-bit 1024-bit 1536-bit Key Life Time:   Sec. Encryption Algorithm: 3DES   (3DES: 24 ASCII) Encryption Key: Authentication Algorithm: MD5   SHA1   (MD5: 16 ASCII SHA1: 20 ASCII) Authentication Key: Inbound SPI:           (HEX 100-FFFFFFFF) Outbound SPI:           (HEX 100-FFFFFFFF)       Status     Advanced     Aggressive Mode NetBios Broadcast                
Home > Screenshots > Linksys > RVS4000 > IPSec VPN