Advanced Wireless Settings for the Linksys WAP610NRouter Sceenshot

Back to the Linksys WAP610N



Screenshots from PortForward.com


Firmware Version:  1.0.00     Advanced Wireless-N Access Point with Dual-Band Setup Wireless Administration Status Basic Wireless Settings | Wireless Security | Wireless MAC Filter | WMM | Advanced Wireless Settings Advanced Wireless Settings --> redirect AP Isolation: Enabled Disabled  (Default: Disabled) Frame Burst: Enabled Disabled  (Default: Enabled) Authentication Type: Auto Open System Shared Key  (Default: Auto) Basic Rate: 1-2 Mbps Default All  (Default: Default) Transmission Rate: Auto 6 Mbps 9 Mbps 12 Mbps 18 Mbps 24 Mbps 36 Mbps 48 Mbps 54 Mbps  (Default: Auto) N Transmission Rate: Auto mcs0: 13.5 Mbps mcs1: 27.0 Mbps mcs2: 40.5 Mbps mcs3: 54.0 Mbps mcs4: 81.0 Mbps mcs5: 108.0 Mbps mcs6: 121.5 Mbps mcs7: 135.0 Mbps mcs8: 27.0 Mbps mcs9: 54.0 Mbps mcs10: 81.0 Mbps mcs11: 108.0 Mbps mcs12: 162.0 Mbps mcs13: 216.0 Mbps mcs14: 243.0 Mbps mcs15: 270.0 Mbps  (Default: Auto) Transmission Power: 100% 50% 25% 12%  (Default: 100%) CTS Protection Mode: Disabled Auto  (Default: Auto) Beacon Interval:  (Default: 100, Milliseconds, Range: 20 - 1000) DTIM Interval:  (Default: 1, Range: 1 - 255) Fragmentation Threshold:  (Default: 2346, Range: 256 - 2346) RTS Threshold:  (Default: 2347, Range: 0 - 2347) List of AOCS restricted channels: Use LDPC: No Yes Use Hidden SSID: No Yes ERP Protection Type: None RTS/CTS CTS2Self Use Overlapping BSS Protection: No Yes 11n Protection Type: None RTS/CTS CTS2Self Enable AP forwarding: No Yes Use reliable multicast: No Yes Use STBC: No Yes Percentage of Maximal Transmit Power: 100% 50% 25% 12% QoS Classification Type: 802.1D 802.1Q -->   --> Save Settings Cancel Changes -->
Home > Screenshots > Linksys > WAP610N > Advanced Wireless Settings