Advanced Settings for the Linksys WET54Gv2Router Sceenshot

Back to the Linksys WET54Gv2



Screenshots from PortForward.com


Linksys WET54GV2 Setup  Advanced   Setup   |   Password   |   Advanced   |   Status   |   Help Use this page to configure the advanced settings for your 2.4GHz (802.11g) wireless network. Click the Apply button at the bottom of the page to save your changes. These settings should only be modified by advanced users.   Advanced    Wireless    Transmission   Rate:   Auto           1 Mbps 2 Mbps 5.5 Mbps 6 Mbps 9 Mbps 11 Mbps 12 Mbps 18 Mbps 24 Mbps 36 Mbps 48 Mbps 54 Mbps -->   (Default: Auto) Performance   Mode     Mixed Mode   G-Only Mode Deny   Un-encrypted   Data     Enable   Disable --> Authentication   Type:  Open Shared Key Auto   (Default: Auto) RTS Threshold:     (Default: 2347, Range: 0 - 2347) Fragmentation   Threshold:     (Default: 2346, Range: 256 - 2346) MAC Address    Cloning Mode:   Disable Enable Auto Manual - Enter MAC Address:     Note: When in Auto mode, the Bridge will use the MAC Address of the device connected to the Ethernet port. Choose Manual if more than one device will be connected to the Bridge and you want to clone the MAC Address of a specific device. SNMP    SNMP V1/V2c   Disable Enable Identification:      Contact:    Device Name:    Location:   SNMP   Community:      Read-Only Read-Write    Read-Only Read-Write -->         
Home > Screenshots > Linksys > WET54Gv2 > Advanced Settings