Advanced Setttings for the Linksys WRP400Router Sceenshot

Back to the Linksys WRP400



Screenshots from PortForward.com


Advanced Routing Firmware Version: 1.00.06     Advanced Settings             PPPoE Relay     Enabled Disabled                   Advanced Routing           NAT     Enabled    Disabled                    Dynamic Routing (RIP)     Enabled    Disabled         Dynamic Routing      RIP :   Disabled LAN & Wireless WAN(Internet) Both                   Static Routing      Route Entries :   1 ( ) 2 ( ) 3 ( ) 4 ( ) 5 ( ) 6 ( ) 7 ( ) 8 ( ) 9 ( ) 10 ( ) 11 ( ) 12 ( ) 13 ( ) 14 ( ) 15 ( ) 16 ( ) 17 ( ) 18 ( ) 19 ( ) 20 ( )                  Enter Route Name :              Destination LAN IP :   . . .            Subnet Mask :   . . .            Gateway :   . . .            Interface :   LAN and Wireless Internet(WAN)                 Operating Mode: If the router is hosting your Internet connection, select Gateway mode. If another router exists on your network, select Router mode. Select Set Number: This is the unique route number, you may set up to 20 routes. Route Name: Enter the name you would like to assign to this route. Destination LAN IP: This is the remote host to which you would like to assign the static route. Subnet Mask: Determines the host and the network portion. Help...                        
Home > Screenshots > Linksys > WRP400 > Advanced Setttings