Management for the Linksys WRP400Router Sceenshot

Back to the Linksys WRP400



Screenshots from PortForward.com


Management Firmware Version: 1.00.06     Management                  Router Account :        -->   Router Access      Router Password :               Re-enter to confirm :                      Web Access      Web Utility Access :   HTTP            HTTPS            Web Utility Access via  Wireless :   Enabled     Disabled                   Remote Access      Remote Management :   Enabled     Disabled            Web Utility Access :   HTTP            HTTPS            Remote Upgrade :   Enabled     Disabled            Allowed Remote IP Address :       Any IP Address               . . . To             Remote Management Port :                      UPnP      UPnP :   Enabled     Disabled            Allow Users to Configure :   Enabled     Disabled            Keep UPnP Configurations  After System Reboot :   Enabled     Disabled            Allow Users to  Disable Internet Access :   Enabled     Disabled                   Multimedia Streaming      RTSP Support :   Enabled     Disabled                 SNMP             Identification      Contact :              Device Name :              Location :              Get Community :              Set Community :              SNMP Trusted Host :              SNMP Trap - Community :              SNMP Trap - Destination :   192.168.15.            SNMPv3 UserName :              SNMPv3 Password :              Re-enter to confirm :       --> IGMP                    Support IGMP Version :   IGMP v1 IGMP v2 IGMP v3            IGMP Proxy :   Enabled     Disabled            Immediate Leave :   Enabled     Disabled            Background :   Blue Gray Red Black       Local Router Access: You can change the Router's password from here. Enter a new Router password and then type it again in the Re-enter to confirm field to confirm. Web Access: Allows you to configure access options to the router's web utility. Help... Remote Router Access: Allows you to access your router remotely. Choose the port you would like to use. You must change the password to the router if it is still using its default password. UPnP: Used by certain programs to automatically open ports for communication. --> Help...                        
Home > Screenshots > Linksys > WRP400 > Management