Advanced Routing for the Linksys WRT54GX2Router Sceenshot

Back to the Linksys WRT54GX2



Screenshots from PortForward.com


Advanced Routing Firmware Version: 1.01.06    Setup    WRT54GX2   Setup Wireless Security Access Restrictions Applications & Gaming Administration Status Basic Setup | DDNS | MAC Address Clone | Advanced Routing Advanced Routing                 NAT MODE   Enable Disable           Dynamic Routing   RIP:   Enable   Disable       Receive RIP versions: BOTH RIP v1 and v2 RIPv1 RIPv2       Transmit RIP versions: BOTH RIP v1 and v2 RIPv1 RIPv2           Static Routing   Select set number: 1() 2() 3() 4() 5() 6() 7() 8() 9() 10() 11() 12() 13() 14() 15() 16() 17() 18() 19() 20()       Enter Route Name:       Destination LAN IP: . . .       Subnet Mask: . . .       Default Gateway: . . .         Interface: LAN & Wireless WAN(Internet)                                       NAT Mode: If the router is hosting your Internet connection, select Enable mode. If another router exists on your network, select Disable . Destination LAN IP: This is the remote host to which you would like to assign the static route. Subnet Mask: Determines the host and the network portion. More...     NAT Mode: If the router is hosting your Internet connection, select Enable mode. If another router exists on your network, select Disable . Dynamic Routing: The router supports RIP protocol to enable the device to update routing information automatically. Destination LAN IP: This is the remote host to which you would like to assign the static route. Subnet Mask: Determines the host and the network portion. More...                            
Home > Screenshots > Linksys > WRT54GX2 > Advanced Routing