IPSec for the Motorola 3347 - QwestRouter Sceenshot

Back to the Motorola 3347 - Qwest



Screenshots from PortForward.com


Qwest Modem Configuration Qwest Modem Configuration Motorola 3347 Modem Status Quick Setup Wireless Setup Utilities Advanced Setup qwest.com help Wednesday, October 20, 2010 9:24:29 AM Broadband Settings IP Addressing DHCP Settings LAN Subnets LAN IP Address WAN IP Address VLAN QoS IP QoS Settings Upstream Remote Management Remote GUI Remote Telnet Routing Dynamic Routing Static Routing Security Admin User Name & Password Advanced Port Forwarding Applications DMZ Hosting Firewall Settings NAT UPnP IPSec Connection Status: Qwest Broadband: CONNECTED   1536 / 736 Kbps ISP Status: CONNECTED IPSec Your Broadband Modem supports 3347 to 3347 IPSec tunnels. 1. Set the IPSec state.    IPSec: Enable Disable 2. Set the tunnel name.        Tunnel Name:   3. Set the IPSec tunnel parameters below.    Pre-Shared Key Type:  ASCII Hex    Pre-Shared Key:    Encryption Protocol: ESP None    Authentication Protocol: AH ESP None    SA Encryption Type: DES 3DES    SA Hash Type: MD5 SHA1    Key Management: IKE    Negotiation Method: Main Aggressive    DH Group: 1 2 5   4. Set the IPSec tunnel addressing.    External Address:    Peer Internal Network:    Peer LAN Netmask:    NAT: Enabled     Disabled      PAT Address:    PFS: Enabled     Disabled     5. Set the IPSec tunnel thresholds.    Soft MBytes:    Soft Seconds:    Hard MBytes:    Hard Seconds:    IPSec MTU:   6. Click "Add" to add a new IPSec tunnel. 7. Click "Apply and Reboot" to save your changes. IPSec Tunnel Entry Name State External Address Encryption Authentication Key Edit No Entries Defined.   Copyright 2010 Qwest, All Rights Reserved