WAN IP Address for the Motorola 3347 - QwestRouter Sceenshot

Back to the Motorola 3347 - Qwest



Screenshots from PortForward.com


Qwest Modem Configuration Qwest Modem Configuration Motorola 3347 Modem Status Quick Setup Wireless Setup Utilities Advanced Setup qwest.com help Wednesday, October 20, 2010 9:22:44 AM Broadband Settings IP Addressing DHCP Settings LAN Subnets LAN IP Address WAN IP Address VLAN QoS IP QoS Settings Upstream Remote Management Remote GUI Remote Telnet Routing Dynamic Routing Static Routing Security Admin User Name & Password Advanced Port Forwarding Applications DMZ Hosting Firewall Settings NAT UPnP IPSec Connection Status: Qwest Broadband: CONNECTED   1536 / 736 Kbps ISP Status: CONNECTED WAN IP Address Your Broadband Modem will automatically assign an IP Address to each device in your network. If you are using an additional Router to assign these IP Addresses, you will need to turn this function Off. 1. Select the item below that is utilized by your ISP. PPPoE PPPoA RFC 1483 Transparent Bridging RFC 1483 via DHCP RFC 1483 via Static IP PPP Auto Connect   2. Enter your PPP User Name and Password. (PPPoA and PPPoE ONLY) PPP User Name PPP Password My ISP does not require a username and password.   3. Select the IP Type. Dynamic IP-DHCP(Default) Single Static IP Address Block of Static IP Addresses(Unnumbered Mode)   Single Static IP Gateway Address(Unnumbered Mode) Subnet Mask(Unnumbered Mode) VIP Mode   4. Select the DNS type. Dynamic DNS Addresses(Default) Static DNS Addresses Primary DNS Secondary DNS   5. Select ATM Encapsulation type. VC-Mux LLC/SNAP   6. Click "Apply and Reboot" to save your changes. Copyright 2010 Qwest, All Rights Reserved
Home > Screenshots > Motorola > 3347 - Qwest > WAN IP Address