RIP for the Motorola MG7550Router Sceenshot

Back to the Motorola MG7550



Screenshots from PortForward.com


Motorola Cable Modem : Router Advanced -> RIP Back Back to Basic Page   Status Basic Router Advanced Router   Wireless Protection & Parental Control   VPN Software Connection Diagnostics Security Event Log Setup DHCP DHCPv6 LAN IPv6 DDNS Backup/Restore Options IP Filtering MAC Filtering Port Filtering Forwarding Port Triggers RIP DMZ Basic Radio WPS RADIUS WEP Guest Access Advanced WMM Scan/Bridge Firewall Basic Firewall EventLog Parental Control IPsec L2TP/PPTP Event Log RIP    RIP Setup       RIP Enable Enable RIP Enable: Enable or Disable RIP. Disabled by default. Note: RIP messages will only be sent when the cable modem/router is configured for Static IP Addressing (see the Basic-Setup page). It is unlikely that your cable Internet service supports this mode. If it does, and you want to enable RIP, you will need to ask for the CMTS's key name and number. You may need additional information.       RIP Authentication Enable RIP Authentication: To turn on RIP MD5 Authentication, select Enable. You need to do this as part of enabling RIP.       RIP Authentication Key RIP Authentication Key: Enter the CMTS's Key you received from your service provider.       RIP Authentication Key ID RIP Authentication Key ID: Enter the CMTS's Key number you received from your service provider.       RIP Reporting Interval (seconds) RIP Reporting Interval: To change the RIP announcement interval, enter a number in seconds. 30 seconds by default.       RIP Destination IP Address . . . RIP Destination IP Address: To specify a RIP unicast destination IP address, enter the IP address and subnet mask.       RIP Destination IP Subnet Mask . . . RIP Destination IP Subnet Mask: To specify a RIP unicast destination IP address, enter the IP address and subnet mask.    Network Name (SSID) -->