VPN IPsec for the Motorola SVG2501Router Sceenshot

Back to the Motorola SVG2501



Screenshots from PortForward.com


Residential Gateway Configuration: VPN - Ipsec   VPN   IPsec           help This page allows configuration of IPsec tunnels.   1.0   tag to ident table -->   Tunnel Tunnel list is EMPTY. Name   Disabled Enabled   Local endpoint settings Address group type IP subnet Single IP address IP address range Subnet  192 . 168 . 0 .  Mask  255 . 255 . 255 .  Identity type Automatically use WAN IP address IP address Fully qualified domain name (FQDN) Email address (USER FQDN) Identity   Remote endpoint settings   Address group type IP subnet Single IP address IP address range Subnet . . . Mask . . . Identity type Automatically use remote endpoint IP address IP address Fully qualified domain name (FQDN) Email address (USER FQDN) Identity Network address type IP address Fully qualified domain name (FQDN) Remote Address   IPsec settings   Pre-shared key Phase 1 DH group Group 1 (768 bits) Group 2 (1024 bits) Group 5 (1536 bits) Phase 1 encryption DES 3DES AES-128 AES-192 AES-256 Phase 1 authentication MD5 SHA-1 Phase 1 SA lifetime seconds Phase 2 encryption DES 3DES AES-128 AES-192 AES-256 Phase 2 authentication MD5 SHA-1 Phase 2 SA lifetime seconds           Key management Auto (IKE) Manual Manual Encryption Key Manual Authentication Key Inbound SPI Outbound SPI IKE negotiation mode Main Aggressive Perfect forward secrecy (PFS) Disabled Enabled Phase 2 DH group Group 1 (768 bits) Group 2 (1024 bits) Group 5 (1536 bits) Replay detection Disabled Enabled NetBIOS broadcast forwarding Disabled Enabled Dead peer detection Disabled Enabled --> NAT traversal Disabled Enabled IP payload compression Disabled Enabled -->       2001-2009 Motorola Corporation. All rights reserved.
Home > Screenshots > Motorola > SVG2501 > VPN IPsec