Wireless AP for the Netgear DGN2200v4Router Sceenshot

NETGEAR Router DGN2200v4 Wireless AP Apply Cancel Wireless AP mode allows this device to work as a stand-alone wireless access point on your existing network. Enable AP Mode Enable fixed IP setting on this device (not recommended) IP Address . . . IP Subnet Mask . . . Gateway IP Address . . . Primary DNS . . . Secondary DNS . . . Please follow these instructions to have the optimal setup and performance: Step1: Make sure this device's Internet port is connected with an Ethernet cable to one of the LAN ports on the existing router. Step2: If your existing router has wireless capability, turn it off or disable it, to avoid interference with this new AP device, Or at least run it at a different wireless channel. Once you are done, click Apply to continue Note: After you click Apply, this device will change to a new IP assigned by your existing router, therefore this web page might not be available. Please close and restart the web browser to http://www.routerlogin.net/ again. Help Center Show/Hide Help Center