LAN IP Setup for the Sky ER110Router Sceenshot
Sky Hub > LAN IP Setup Sky Hub Wireless Powerline Ethernet Security Maintenance Advanced Support Licence Information Logout Wireless Settings Wireless WPS Logs Block Sites Firewall Rules Services Schedule Router Status Attached Devices Backup Settings Set Password Diagnostics Router Upgrade WAN Setup Dynamic DNS LAN IP Setup Remote Management UPnP LAN TCP/IP Setup Configure these settings if your network contains multiple routers. If you make any changes to these settings you will need to restart your computer(s) and devices(s) for the settings to take effect. LAN TCP/IP Setup help IP Address: . . . IP Subnet Mask: . . . Use Router as DHCP Server help Starting IP Address: . . . Ending IP Address: . . . Address Reservation help # IP Address Device Name MAC Address Add Edit Delete Cancel Apply LAN TCP/IPv6 Setup help Enable Router Advertisements Daemon --> Enable IPv6 on LAN side help Enable ULA Router Prefix Advertisements help Prefix randomly generated Prefix manually configured Prefix: Preferred Lifetime (hour): Valid Lifetime (hour): Enable IPv6 DHCP Server help Enable MLD Querier help Cancel Apply LAN TCP/IP Setup IP Address: Type the IP address of your Sky Hub, the factory default is: 192.168.0.1 IP Subnet Mask: Your Sky Hub will automatically calculate the subnet mask based on the IP address that you assign. Unless you are implementing subnetting use 255.255.255.0 as the subnet mask. Use Your Sky Hub as a DHCP Server Your Sky Hub is set by default as a DHCP (Dynamic Host Configuration Protocol) Server, which provides the TCP/IP configuration for all the devices that are connected to it Starting IP Address: This box specifies the first of the contiguous addresses in the IP address pool. 192.168.0.2 is the default start address Ending IP Address: This box specifies the last of the contiguous addresses in the IP address pool. 192.168.0.254 is the default ending address Address Reservation When you specify a reserved IP address for a device on the LAN, that device will always receive the same IP address each time it accesses the DHCP server. Reserved IP addresses should be assigned to servers that require permanent IP settings. To Reserve An IP Address: Select Add Select the radio button of the device you wish to add from the Address Reservation Table If the device isn't on the Address Reservation Table enter the IP Address, MAC Address, and Device Name of the device you wish to add Select Add when finished To Edit A Reserved IP Address: Select the radio button next to the reserved address you wish to edit Select Edit To edit the IP Address, MAC Address or Device Name: Select Apply when finished To Delete A Reserved IP Address Select the radio button next to the reserved address you wish to delete Select Delete LAN TCP/IPv6 Setup In this section you can change the IPv6 related router settings. Enable IPv6 on LAN side Enable/Disable all LAN IPv6 features. Enable ULA Router Prefix Advertisements Enable/Disable unique local address prefix advertisements from router. Prefix randomly generated: Router will randomly generate prefix for you. Prefix manually configured: You can configure ULA prefix manually. Prefix should be of format fdxx:xxxx:xxxx:xxxx::/64 Enable IPv6 DHCP Server Your Sky Hub is set by default as a DHCP IPv6 (Dynamic Host Configuration Protocol) Server, which provides the IPv6 configuration for all the devices that are connected to it. Router will provide only network settings to connected devices. Enable MLD Querier Your Sky Hub is set by default as a non MLD (Multicast Listener Discovery) Querier. Router will not send MLD Listener Query messages to query for the presence of listeners in each multicast group.