Remote Management for the Sky ER110Router Sceenshot

Back to the Sky ER110



Screenshots from PortForward.com


Sky Hub > Remote Management Sky Hub Wireless Powerline Ethernet Security Maintenance Advanced Support Licence Information Logout Wireless Settings Wireless WPS Logs Block Sites Firewall Rules Services Schedule Router Status Attached Devices Backup Settings Set Password Diagnostics Router Upgrade WAN Setup Dynamic DNS LAN IP Setup Remote Management UPnP Remote Management Using the Remote Management menu, you can allow a user on the Internet to configure, upgrade and check the status of your Sky Hub Important: If you enable remote management it is advisable to change your Sky Hub default password to a very secure password Turn Remote Management On help Remote Management Address help http://:8080 Allow Remote Access To help None (IPv4): Everyone (IPv4): Only This Computer (IPv4): . . . IP Address Range: From . . .   To . . . help None (IPv6): Everyone (IPv6): Only This Computer (IPv6): IPv6 Address Range: From   To Port Number: help Cancel Apply Turn Remote Management On Select the check box to Turn Remote Management On Select Apply to save changes Remote Management Address This is the current address you will use when accessing your Sky Hub from the Internet. To access the Sky Hub remotely type your Sky Hub's global IP address into your browser's Address or Location bar, followed by a colon (:) and the custom port number. e.g. if your external address is 10.0.0.123 and you use port number 8080, enter http://10.0.0.123:8080 Allow Remote Access For security, you should restrict access to as few external IP addresses as practical Select Everyone to allow access to everyone on the Internet Select Only This Computer to allow access by only one IP address Select IP Address Range to allow access from a range of IPv4 addresses on the Internet, enter a beginning and ending IPv4 address to define the allowed range IPv4 Preferred Port Number Web browser access normally uses the standard HTTP service port 80. For greater security, you can change the remote management web interface to a custom port by entering that number in the box provided. Choose a number between 1 and 65534, but don't use the number of any common service port. It is not guaranteed that the same port requested by the user will be available for use, especially in a CGNAT environment where same global IP address is shared between multiple devices. Hence, refer the "Remote Management Address" field above for the actual port number to be used for remote management access.It is not possible to manually set an IPv4 Port Number on CGN carrier grade network connections, the port will be automatically allocated by the network. For security, you should restrict access to as few external IP addresses as practical Select Everyone to allow access to everyone on the Internet Select Only This Computer to allow access by only one IP address Select IPv6 address range to allow access from a range of IPv6 addresses on the Internet. Enter the beginning and ending IPv6 address to define the allowed range.
Home > Screenshots > Sky > ER110 > Remote Management