Channel Config for the Telsec TS-9000Router Sceenshot

Back to the Telsec TS-9000



Screenshots from PortForward.com


ADSL Connection Mode Channel Configuration This page is used to configure the parameters for the channel operation modes of your ADSL Modem/Router. Note : When connect type of PPPoE and PPPoA only is "Manual", the "Connect" and "Disconnect" button will be enable. Default Route Selection:    Auto Specified   VPI:    VCI:          Encapsulation: LLC   VC-Mux Channel Mode: 1483 Bridged 1483 MER PPPoE PPPoA 1483 Routed IPoA        Enable NAPT: Enable IGMP: Admin Status: Enable   Disable -->    PPP Settings: User Name: Password: Type: Continuous Connect on Demand Manual Idle Time (min): WAN IP Settings: Type: Fixed IP DHCP Local IP Address: Remote IP Address: Netmask: Default Route: Disable Enable   Auto Unnumbered --> Current ATM VC Table: Select Inf Mode VPI VCI Encap NAPT IGMP DRoute IP Addr Remote IP NetMask User Name Unnumber Status Edit a0 br1483 5 35 LLC Off Off Off 0.0.0.0 0.0.0.0 0.0.0.0 --- --- up pppoe1 PPPoE 0 35 LLC On Off On 189.31.22.113 201.34.54.254 255.255.255.255 aldo.26@ig.com.br --- up
Home > Screenshots > Telsec > TS-9000 > Channel Config