IP QoS for the Telsec TS-9000Router Sceenshot

Back to the Telsec TS-9000



Screenshots from PortForward.com


IP QoS IP QoS Entries in this table are used to assign the precedence for each incoming packet based on specified policy. Config Procedure: 1: set traffic rule. 2: assign the precedence or add marker for different stream. IP QoS: disable  enable   QoS Policy: stream based 802.1p based DSCP based Schedule Mode: strict prior WFQ(4:3:2:1) QoS Rule List: stream rule behavior src IP src Port dest IP dest Port proto phy port prior IP Precd IP ToS 802.1p wan itf sel         Add QoS Rule Src IP: Src Mask: Dest IP: Dest Mask: Src Port: Dest Port: Protocol: TCP UDP ICMP Phy Port:    LAN USB   set priority: p3(Lowest) p2 p1 p0(Highest) assign WAN interface: pppoe 1 --> insert or modify QoS mark     IP Precedence:                      0 1 2 3 4 5 6 7     IP ToS:                   Normal Service Minimize Cost Maximize Reliability Maximize Throughput Minimize Delay     802.1p:                      0 1 2 3 4 5 6 7
Home > Screenshots > Telsec > TS-9000 > IP QoS