PPP Connection Help for the Tilgin Vood 322Router Sceenshot

Back to the Tilgin Vood 322



Screenshots from PortForward.com


>Help>PPP Help --> 2000-2007 Tilgin. All rights reserved. Copyright and Trademark. HOME SETUP VOIP SWITCH ADVANCED WIRELESS TOOLS STATUS ACCOUNT PHONE HELP Help Firewall Bridge Filters LAN Clients LAN Group Configuration PPP Connection Voice UPnP IP QoS RIP Help Log Out PPP Connection Help Username: The username for the DSL access. Password: The password for the DSL access. Authenication: Specifies the authenication protocol required to establish connection. On-Demand: Enable on-demand mode. The connection will disconnect if no activity is detected after the specified idle timeout value. Idle Timeout: Specifies that DSL should disconnect if the link has no activity detected for n seconds. A non-zero value. Keep Alive: When on-demand option is not enable, this value specifies the time to wait without being connected to your provider before terminating the connection. A non-zero value. Set Defaultroute: Specify connection as the default-route. MRU: Maximum Receive Unit the DSL connection can receive. It is an negotiated value that ask the provider to send packets of no more than n bytes. The minimum MRU value is 128. Enforce MRU: Check this box if you experience problems accessing the Internet over a PPPoE connection. This feature will force all TCP traffic to conform with PPP MRU by changing TCP Maximum Segment Size to PPP MRU. Debug: Enables PPP connection debugging facilities. Connect: Use the current settings to establish a ppp connection. In "On Demand" mode "Connect" takes no action in establishing connection. Disconnect: Disconnects the ppp connection.
Home > Screenshots > Tilgin > Vood 322 > PPP Connection Help