WAN Configuration for the Zoom X5 5654BRouter Sceenshot

Back to the Zoom X5 5654B



Screenshots from PortForward.com


WAN Configuration Use this page to quickly configure the system. I want to configure my modem: MANUALLY (because I have a static IP address and/or because I already know my Encapsulation, VPI, and VCI settings). AUTOMATICALLY (because I am NOT using a static IP address and I do NOT know my Encapsulation, VPI, and VCI settings). AutoConfigure: Enable      Disable   Select Enable , then click Save Changes Autodetect Mode:   Bridge Router Bridge & Router VPI VCI Encapsulation Protocol Detected 0 35 PPPoE                   After you have saved your changes, you must write the new settings to flash to make them permanent. Click the button below to do this. Current Connection Enabled Disabled Encapsulation:   PPPoA VC-Mux PPPoA LLC PPPoE VC-Mux PPPoE LLC 1483 Routed IP VC-Mux 1483 Routed IP LLC 1483 Routed IP LLC(1577) 1483 Bridged IP VC-Mux 1483 Bridged IP LLC None VPI:   VCI:   Bridge:   Enabled Disabled IGMP:   Enabled Disabled IP Address:   Subnet Mask:   Use DHCP:   Enable Disable Default Route:   Enabled Disabled Gateway IP Address:   PPP Username:   Password:   DNS Use DNS:   Enable Disable Primary DNS Server:   Secondary DNS Server:   Virtual Circuit:   0 1 2 3 4 5 6 7 After you have saved your changes, you must write the new settings to flash to make them permanent. Click the button below to do this. To Return to the Wan Configuration page after saving changes click on Advanced Status then Wan Configuration.
Home > Screenshots > Zoom > X5 5654B > WAN Configuration